The customer’s demand for the coupling is the responsibility of the machine, and the requirement is the standard of the coupling manufacturer

   standardCouplingIt is determined by the customer. How do you say this? A customer from Tianjin called to say a few days ago.Coupling, The company processed according to its proofreading requirements. Because the coupling is very special-shaped, the outer diameter of the coupling is 500mm, the outer circle of the shaft hole is 300mm, and the diameter of the hole is 240mm. After recalling that the customer’s shaft hole requirements are (The standard hole is better to minus 0.1mm). Just this sentence is good. If there is no technical focus, it will be processed according to the standard. The hole will be added with a size within the standard range of 0.05mm. As a result, when the goods are actually used, the shaft will be added. After the research damage to 0 line, 0.04mm is reduced. As a result, the coupling is easily installed. Originally, the customer wanted to hot-install it. It was more durable. In this way, the customer put forward the words "good reduction o.1", the company The coupling was repaired, which caused a certain loss to be worthless, but caused inconvenience to the customer. The company will be very guilty!Machinery must not make the same mistakes in the future. The customer’s needs of the coupling are the responsibility of the machinery.Coupling manufacturersStandard.