The key to the manufacture of non-standard couplings-torque//machine factory

                                    Torque is non-standardCouplingRuler

   There are quite a few in the machinery industryCouplingIn order to achieve the working quality of the equipment, the customer has changed the transmission power of the machine and increased the working rate of the machine. Therefore, the original coupling cannot reach the modified transmission force of the equipment, which producesNon-standard coupling.mechanicalIn the past few years, the factory has not conducted research and development to investigate the rationalization of this type of coupling. Over time, the company has designed an axiom---the selection of non-standard couplings depends on its torque. The following practices have proved: a chemical plant The coupling on the mixing unit is GIICL7Gear coupling, At first, it stirred the liquid with a concentration of 35. Later, the company made its own changes to stir it with a concentration of 45. The coupling on the original machine broke after a few days. The torque was too large and the gears were beaten. Later, a set was changed. The gear coupling of CIICL8 will work by then. In the state of feeding the mark once, the motor was burnt due to the working torque mark, the coupling has no limited protection ability, the torque is too large, and so on. The selection of the coupling must consider its torque.So far, if you have any difficulties with couplings, please find machinery and entities.Coupling manufacturersWill solve the problem for you, the concept of mechanical design is that the scale of non-standard coupling is torque.