Steel partsCouplingInstead of cast ironCouplingThe model can be reduced such asPlum couplingThe 4# steel of ML45 completely replaces the elastic three-jaw product with an outer diameter of 120 mm. The load of the dynamic shaft system is often changed. There are many reasons for the change of the plant load. It may be due to the unstable driving force of the power machine, such as the drive of an internal combustion engine. The torque changes periodically; it may also be due to the unstable load of the working machine. For example, the negative force of the reciprocating 5t compressor and crusher changes periodically, which is the random fluctuation of Wu.In addition, the wooden body of the transmission system may also generate dynamic loads, such as the impact caused by the change of the hoist ratio caused by the tooth profile of the gear transmission in China and the benzene joint error. Another example is the centrifugal force caused by the unevenness of the rotating parts in the shaft pump. The move to cut the lottery and so on.due toFlexible couplingIt can adapt to the fluctuation of teaching and charge, so it has a wide range of applications and many types.The cushioning andThe vibration absorption performance is mainly related to its stiffness and damping.Therefore, stiffness and damping are one of the basic issues considered in the selection and design of elastic couplings.
Therefore, the torque of ML4 products can be compared according to the national standard torque, which is almost greater than the cast iron connector products with an outer diameter of 130 mm!In terms of service life, steel parts are much larger than fragile cast iron products!Welcome customers to inquire!